Wednesday, April 18, 2012

Will stacked ND filters perform as well as a single 10 stop ND filter?

Question

I have the Tiffen 0.9 ND filter which gives me approximately 3f stops reduction. I like to really slow things down and although it's sufficient in low light it just won't do in daylight.

Should I get a pair of 2 more 0.9 ND filters to stack or should I would a single say 10 stop filter be a better solution? Will the stacked ND filters perform as well as a single 10 stop filter?

I would like to be able to slow things down to the point where I get similar results to this photo which was shot at f4, ISO 200 and 75 seconds.

Asked by Jakub

Answer

From a functional standpoint, yes, you could essentially achieve the same effect with multiple stacked filters as a single high-density filter (say a 10-stopper.) There are a variety of concerns to be aware of, however, regarding stacking multiple filters.

  1. Filter quality:
    • The Lee "Big Stopper" 10-stop ND filter is pretty high quality glass filter
    • There are two Lee ProGlass filters (0.6 and 0.9) of the same quality
    • The full range of standard Lee ND filters, (0.3, 0.45, 0.6, 0.75, 0.9) are resin
    • Many third-party filters are resin, a very few are glass
  2. Color cast:
    • Stacking lots of resin filters can cause strange color casts
    • With digital, color cast is usually an easy post-process fix
  3. Vignetting:
    • Stacking enough resin filters means a pretty thick hunk of junk on the end of the lens
    • At least four resin ND filters (0.3/1stop, 0.6/2, 0.9/3, 1.2/4) are needed to match a single 10-stop filter
    • On wider-angle lenses, you can barely get away with two stacked filters let alone four without vignetting
  4. Flaring:
    • Any additional optical device added to the light path adds the potential for flare and ghosting
    • Stacking four ND filters adds a total of 8 additional surfaces which can reflect
    • To my knowledge, no 4x4/100mm filters are multicoated, so their chances of flaring/ghosting are high
  5. Versatility:
    • A single 10-stop filter still leaves you some room to also stack on a graduated ND filter to balance contrast

If you want to do some serious ND work, such as 5 minute exposures of sunset along the coast, you should get a 10-stop filter. You'll probably also need at least one GND to normalize scene contrast if you are photographing a sunset/sunrise, which would usually require a setup like the Lee base filter kit with a tandem adapter and an additional independent filter holder (for a total of up to 8 filters)...that is pretty much guaranteed to add vignetting on anything other than a telephoto lens.

Answered by jrista

No comments:

Post a Comment